Overview

This article provides the steps required to access Kerio Control's shell using Secure Shell (SSH). This is helpful when you need to perform general troubleshooting, specifically on network issues in Kerio Control. By default, SSH access is disabled in out of the box installations of Kerio Control.

Solution

1. Log in to the Kerio Control administration interface.
2. While holding the Shift button on your keyboard, navigate to Status > System Health.
3. Enable SSH by clicking the Enable SSH button.
    
   
   
4. Confirm security warning by clicking Yes.
   
   
5. Click OK to close the informational window.
   
   
6. In your secure shell program, open a new connection to Kerio Control's server address. The command for Linux/macOS is ssh root@<control_ip_address>, i.e. ssh root@10.10.10.1
   

   Note: IP address varies depending on the Network configuration.

7. When asked for the credentials, enter root for login as and your local administrator password for root's password.
   
   
    

Testing

 To test the SSH you can perform the following actions for example:

Identifying Kerio Control Webadmin URL from SSH

1. Run ls command and check if the admin.url is listed or not.
   
   
    
2. If listed, then run nano admin.url. The Kerio Control administration URL will be displayed.
   
   

Displaying Linux Kernel Module Information

1. Navigate to the wireless network drivers directory.
    
   

   cd /lib/modules/3.16.0-k4-kerio-amd64/kernel/drivers/net/wireless/ath
   

    
2. Run the modinfo command for the necessary driver (i.e., ath10k_pci).
   
   

   modinfo ath10k_pci

   
   
    

Back to top