Overview
Kerio Control allows automatic configuration of the DHCP server. This option involves automatic creation and update of IP address ranges and parameters by network interfaces included in Trusted/Local Interfaces, Guest Interfaces and Other Interfaces groups, which implies that the only action required to be performed is to run the DHCP server itself. This article provides the steps necessary to run the DHCP server.
Process
- In Kerio Control's administration interface, go to DHCP Server.
- Select Enable DHCP server.
- Click Apply to save the changes.
Warning: Kerio Control does not ping an IP address before assigning it via DHCP. Make sure there are no static addresses assigned to any network devices also configured in the DHCP range.
Confirmation
For each interface's subnet, the scope of the following parameters will be created:
| Parameters |
Description |
| Range |
By IP address of the interface and the corresponding subnet mask. The range should cover the particular subnet with free resources for assigned static addresses, e.g., for mask If a range covers an interface's address, then an exception is automatically defined for it. |
| Subnet Mask |
According to the particular interface. |
| Default Gateway |
The IP address of the particular interface. |
| DNS Server |
The IP address of the particular interface. |